Smart-technologies SMART BOARD 4000I User Manual download pdf (Page 52)

42 Using the 4000i

Table 2: Startup Scenarios

What You See System/Projector State What You Should Do

A blank screen and the Lamp

Status LED blinking very slowly

The projector is in standby

mode, with the lamp off.

Press the Projector Standby

button on the control panel.

The Lamp Status LED flashes

moderately fast for approximately

40 seconds and then your

computer’s video output appears

and the LED glows steady.

The A/V mute screen, the

Lamp Status LED blinking and

any Active Display Source LED

illuminated

NOTE: See page 35 for details

on setting the A/V mute

screen.

The projector lamp is powering

up. The computer’s video

output appears after

approximately 40 seconds.

Wait for the computer video output

to appear.

A blank screen and the Lamp

Status LED blinking slowly.

However, when you press the

Projector Standby button, no

image appears.

The projector lamp is not

properly warming up and the

projector may be experiencing

problems that interfere with

normal operations.

Examine the Projector Status LED

on the projector. You can see this

LED when you open the front doors

of the 4000i. Read the Epson

PowerLite 9300i Multimedia

Projector User's Manual for

assistance.

The A/V mute screen, the

Lamp Status LED blinking very

fast and no Display Source

LED illuminated

The projector lamp is in

reversible standby mode.

Press any button on the control

panel to instantly restore the

image.

If you allow this state to continue

for five minutes, the LED indicator

will begin to blink slowly, and then

move to standby mode after an

additional 50 seconds.

The computer image The projector lamp is on and

functioning normally.

Log on as usual using the wireless

keyboard or press the Keyboard

button on the pen tray to use the

SMART Keyboard.

The A/V mute screen and the

Lamp Status LED illuminated

steadily

The projector lamp is powered

up, but the computer is either

off or in standby mode.

Check that the computer is on, and

if it’s not, turn it on.

If the computer is on, press a key

on the wireless keyboard to wake it

up.

The A/V mute screen, and the

Lamp Status LED blinking very

slowly

The projector lamp is in

standby mode.

Touch the interactive screen or

press the Display Source button

to reactivate the projector lamp.

All the LED indicators on the

control panel blinking

The system isn’t currently

detecting a projector.

Check that the projector is

connected as described on

page 18. Read the Epson

PowerLite 9300i Multimedia

Projector User's Manual for

assistance.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 93 94

Comments to this Manuals

No comments