Smart-technologies SMART BOARD 4000I User Manual download pdf (Page 19)

Setting Up the 4000i 9

Installing the Laptop Shelf

You can install the laptop shelf on either side of the cabinet. You should install the shelf before

you install the computer, because it’s easier to remove the plastic hole covers when the

computer is not inside the cabinet. If you install the shelf on the right-hand side (when you face

the interactive whiteboard), take care not to knock the infrared (IR) receiver that’s installed on

the lower corner of the screen.

You can also attach the J-hook to the handle recess so you can route the umbilical cables

through this hook to the guest laptop shelf. You’ll find this hook in the accessory kit.

Figure 6: The Location of the Guest Laptop Shelf and J-Hook

1. Locate the two laptop shelf keyholes and the single thumbscrew hole on the side of

the cabinet. Remove the plastic hole covers.

2. Push the two protruding bolts on the edge of the shelf into the two keyholes, and then

push the shelf firmly down.

3. Push the captive thumbscrew at the bottom of the shelf into the thumbscrew hole and

tighten.

To install the guest laptop shelf

One Location for the Guest Laptop Shelf

One Location for the J-hook

NOTE: The IR receiver isn’t

shown in this illustration.

Two Keyholes

Thumbscrew Hole

NOTE: The IR receiver isn’t

shown in this illustration.

NOTE: The IR receiver isn’t

shown in this illustration.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 93 94

No comments

Smart-technologies SMART BOARD 4000I User Manual Page 19