Smart-technologies SMART BOARD 4000I User Manual download pdf (Page 31)

Setting Up the 4000i 21

15. Turn the projector adjustment knob on the mounting bracket until the projector has

moved about 3/8" (1 cm). (You’ll fine-tune this setting on page 32.)

16. Tighten the four mounting screws that hold the projector to the mounting bracket using

the M4 hex key.

17. Remove the lens cap from the projector.

18. Check that the cables that are connected to the projector have no sharp bends or

stress points in the final position.

19. Route the cable bundles along the sides of the projector mount and snap the

releasable tie wraps into the three holes on the mounting bracket.

Projector Adjustment Knob

The projector moves this way

NOTE: For clarity, this illustration shows the mounting

bracket out of the 4000i. Also, no cables are shown.

Tighten these screws (two

shown, four in total)

NOTE: For clarity, this illustration shows the mounting

bracket out of the 4000i. Also, no cables are shown.

Holes for Cable Ties (x3)

NOTE: For clarity, this

illustration doesn’t show the

side panel or any cables.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

No comments

Smart-technologies SMART BOARD 4000I User Manual Page 31