Smart-technologies SMART BOARD 4000I User Manual download pdf (Page 41)

Setting Up the 4000i 31

Powering up the 4000i

When you’ve connected all your devices to the 4000i, you’re ready to connect the main power

cable and power up the internal computer and the projector. After you do this, you must

finalize your installation, as described in the next section (page 32).

1. Locate the AC power cord in the power kit.

2. Plug this cord into the Main Power IN port, located to the right of the connection

panel.

Figure 18: The Location of the Main Power Inlet

3. Plug the other end of the power cord into an electrical outlet.

The Power LED on the projector should glow orange, indicating that it’s receiving

power.

4. Turn on the computer.

5. Remove the projector lens cap, if you haven’t already done so.

6. Power on the projector by pressing the Power button on the projector’s remote

control.

NOTE: Make sure the remote control is turned on.

The Power LED on the projector flashes green while the projector warms up (about 40

to 100 seconds). This LED will glow solid green when the projector is ready to use,

and you’ll see an image on the interactive whiteboard.

If you don’t see an image after about a minute, press the Projector Standby button

on the control panel. The LED indicator beside this button should blink for 40 seconds,

and then remain steadily illuminated after the projector lamp powers up.

To connect the main power cable

Main Power IN

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 93 94

No comments

Smart-technologies SMART BOARD 4000I User Manual Page 41