Smart-technologies SMART BOARD 4000I User Manual download pdf (Page 65)

Maintaining and Troubleshooting the 4000i 55

Adjusting the Projector Settings

The projector is configured for optimal performance within the 4000i. However, if these

settings are altered, you can easily restore them.

By setting the standby mode to Network On, you allow the projector to go into standby mode

instead of full sleep mode.

The numeric default value for the Contrast and Brightness settings is zero. Read the Epson

PowerLite 9300i Multimedia Projector User’s Guide for more information on the projector’s

settings. Also, to use the remote control, first press its Power button.

1. Press the Menu button on either the projector remote control or on top of the

projector.

2. To reset the options on a particular menu, select that menu from the Menu List and

then select the Reset option.

To reset all options, select the Reset All option on the Menu List.

NOTE: When you reset all options, the Input Signal, User’s Logo, Language,

Projector ID, Network and Lamp settings remain the same.

3. Press the ESC button.

1. Press the Menu button.

2. Select Video from the Menu List.

3. Select Auto beside the Contrast option and press Enter.

Select Manual beside the Contrast option and press Enter.

4. If you’ve selected Manual, enter your contrast settings, as needed. Refer to the

Epson PowerLite 9300i Multimedia Projector User’s Guide for more details.

5. Press Adjustment.

6. Press the ESC button.

1. Select the Menu button.

2. Select Advanced1 from the Menu List.

3. In the Standby Mode area, select Network On.

4. Press Enter.

5. Press the ESC button.

IMPORTANT

Do not modify the following settings:

• Standby Mode, which must be set to Network ON

• Contrast, which must be set to Manual

To set or restore the projector settings

To adjust the Contrast setting

To adjust the Network setting

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 93 94

No comments

Smart-technologies SMART BOARD 4000I User Manual Page 65