Smart-technologies SMART BOARD 4000I User Manual download pdf (Page 43)

Finalizing the Installation 33

1. Loosen the lockdown bolt on the underside of the projector mounting bracket using a

7/16" wrench (in the accessory kit).

2. With these fasteners loosened, shift the entire projector mounting bracket to the right

or to the left.

3. If you need to slightly adjust the rotation of the projected image (its roll), you can

tighten the spring-loaded screws on one side and then shift the projector.

4. After you’ve made these vertical adjustments, check the image on the interactive

screen. You may need to turn the adjustment knob on the projector mount to make the

image appear larger or smaller.

To adjust the image position

Lockdown Bolt

NOTE: For clarity, this illustration shows the mounting

bracket out of the 4000i. Also, no cables are shown.

Projector Mounting Bracket

Loosen the screws on this

side and rotate the projector

on the mounting bracket to

correct image roll

Projector Mounting Bracket

Loosen the screws on

this side and rotate the

projector on the

mounting bracket to

correct image roll

NOTE: For clarity, this illustration shows the mounting

bracket out of the 4000i. Also, no cables are shown.

Adjustment Knob

NOTE: For clarity, this illustration shows the mounting

bracket out of the 4000i. Also, no cables are shown.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 93 94

No comments

Smart-technologies SMART BOARD 4000I User Manual Page 43