Smart-technologies Sympodium ID250 User Manual download pdf (Page 9)

Installing the ID250 3

Installing the ID250

This chapter tells you how to:

• determine the best location for the ID250 (this page)

• connect the ID250 (page 4)

• integrate a monitor or a projector (page 4)

• install SMART Board software (page 4)

• orient the screen (page 5)

• match your computer’s resolution setting to that of the interactive screen (page 6)

• adjust the screen settings (page 6)

• tether the pen (page 8)

• secure the ID250 (page 8)

You can connect the ID250 to another monitor or an external projector so that the interactive

screen display is simultaneously displayed on the other screen (page 4). There are other

integration options available if you amplify the video signal (page 8).

NOTE: For the ID250 to function properly in XGA mode (1024 x 768 resolution), you must set the

computer’s vertical refresh rate between 45 Hz and 70 Hz. However, if you’re using a mode less

than XGA, your refresh rate can be between 45 Hz and 75 Hz.

Determining the Best Location for Your ID250

When you’re deciding where to place your interactive pen display, consider the location of the

computer and its components in relation to the ID250.

Install the ID250 in a cool, dry location without excessive levels of dust, humidity and smoke.

Operate the ID250 in an environment with a temperature range between 41° F and 95° F (5° C to

35° C) and with a humidity range of 20% to 80% (non-condensing). You can store the ID250 in an

environment with a temperature range of 14° F to 140° F (-10° C to 60° C) and a humidity range of

20% to 90% (non-condensing).

NOTE: Take into consideration that the ID250 itself will generate heat whenever it’s turned on. To

maintain a consistent operating temperature, don’t block or cover any of the ventilation holes on

the back of the unit. Other external factors can affect the ID250, such as the heat generated by

control systems or other electronic equipment. Ensure there is adequate airflow around the ID250.

Keep the computer keyboard and the mouse close to the ID250, because the pen won’t function

until you install SMART Board software and open the SMART Board tools. You should also keep

your computer within 19 1/2' (6.0 m) of the ID250. This distance protects against signal

degradation that occurs as the USB cable length increases. The video cable also has distance

limitations, so you shouldn’t use an RGB video cable that’s longer than 50' (15 m).

CAUTION

Connect only the cables provided with your ID250. Other cables can cause

damage.

Also, don’t connect the video or power cables if the ID250 or your computer is on.

Doing so can damage the ID250 or your computer.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

No comments

Smart-technologies Sympodium ID250 User Manual Page 9