Smart-technologies SMART Board 800i5-SMP User Manual download pdf (Page 88)

The following table describes the power state fields:

Field Description

Powering The projector is turning on.

On The projector is on.

Cooling The projector is cooling.

Confirm off Confirm off is a non-selectable power state that is returned during

stage one of the two-button Off sequence.

Idle The projector is off but still receiving power (Standby mode).

Source selection controls

These commands switch input sources. The source type determines which commands can be

accepted.

Command Response Available in Standby

mode

get input input=[field] Yes

set input=[field] input=[field] No

The following table describes the source selection commands:

Command Description

get input Returns the projector’s current input.

set input=[field] Sets the input to one of the selectable fields.

The following table describes the source selection response fields:

Field Description

VGA1 Switches source to the VGA 1 input connector.

VGA2 Switches source to the VGA 2 input connector.

Composite Switches source to the Composite video connector.

If you installed your interactive whiteboard system according to the

instructions, this is the relay from the ECP.

S-Video Switches source to the S-Video input connector.

HDMI Switches source to the HDMI input port.

None A non-selectable value that appears when you enter a “get input”

command while the projector is in Standby mode.

General source controls

The following source controls apply to all input sources. HDMI connector source controls are

described in this section. These controls are unavailable when the projector is in Standby mode. You

can specify custom color values for all inputs.

These commands inform you of the current source settings.

A P P E N D I X B

Remotely managing your system through an RS-232 serial interface

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 105 106

No comments

Smart-technologies SMART Board 800i5-SMP User Manual Page 88