Smart-technologies SMART Board 800i5-SMP User Manual download pdf (Page 87)

>set brightness-15

brightness=55

Video source specification values

You can use the source input field described in Source selection controls on next page in a command

to set an absolute value or adjustment value to a source other than the active source. You can do this

while the selected source is inactive, but the source device must be connected or you will receive an

invalid command response.

See the following examples, where both an HDMI connector and a VGA 1 input are connected:

>set input=hdmi

input=hdmi

>set brightness vga1=65

brightness vga1=65

>set brightness vga1-7

brightness vga1=58

Power state controls

These commands put the projector in and out of Standby mode and request the projector’s current

power state. The projector’s power state determines whether certain commands are available at that

time. These settings are available even when the projector is in Standby mode.

Command Response

on powerstate=[field]

off powerstate=[field]

off now powerstate=[field]

get powerstate powerstate=[field]

The following table describes the power state commands:

Command Description

on Turns on the projector.

off Starts the shutdown process. A dialog box appears with the

message, “Press Power Button to Turn off Projector.” You must send

a second Off command within 10 seconds to put the projector into

Standby mode.

off now Shuts down the projector immediately. You can’t delay or cancel this

command.

get powerstate Indicates the projector’s current power state.

A P P E N D I X B

Remotely managing your system through an RS-232 serial interface

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 105 106

No comments

Smart-technologies SMART Board 800i5-SMP User Manual Page 87