Smart-technologies Smart board Interactive Whiteboard system 400iv User Manual download pdf (Page 36)

Replacing the projector lamp

This section provides detailed instructions for replacing the projector lamp.

Removing and replacing the projector lamp module

If the lamp fails, or if a replacement message appears on the SMART V25 projector screen, have a

qualified person replace the projector lamp module.

W  W A R N I N G

l Read the warnings and other important information at the beginning of this document before

attempting this procedure.

l Disconnect the power cable from the wall outlet before performing the following procedure.

l Two people are required to remove the projector from the boom and then replace it after

replacing the projector lamp module.

N  N O T E

Make sure that you have a replacement projector lamp ready before accessing the service panel.

You need a Phillips® No. 2 screwdriver and an M3 hex wrench to perform the following procedure.

g To remove the projector from the boom

Press the Power button twice on the remote control to put the system into Standby mode.

2. Wait at least 45 minutes for the projector to cool down completely, and then disconnect the

power cable from the power outlet.

3. Disconnect all cables from the projector.

C H A P T E R 5

Maintaining your interactive whiteboard system

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

No comments

Smart-technologies Smart board Interactive Whiteboard system 400iv User Manual Page 36