Smart-technologies 4000i User Manual download pdf (Page 30)

24 Basic Operations 99-00582-20 REV A0

LinQ software

With LinQ software, you can link a laptop to a SMART interactive product. After you establish a

connection, you can use LinQ software to show the laptop’s video output on the interactive screen.

To establish a communication link between the 4000i and a laptop, you must:

• install and open LinQ software on the laptop computer.

• be connected to the same network as the 4000i’s internal computer.

• start the mobile device manager software on the 4000i’s internal computer.

For more information about LinQ software and mobile device manager software, see

http://www2.smarttech.com/st/en-US/Support/Downloads/LinQ/.

Changing the Projector’s Display Source

You can use the three source buttons on the control panel to change the projector’s video and

audio input source. Choose from the internal computer, a connected guest laptop or an external

computer, a VCR or a DVD player.

NOTE: It takes a few seconds for the 4000i to switch from one input source to another. During that

time, all control panel buttons are disabled.

Press the VCR/DVD Player button on the control panel.

If both a VCR (composite video connection) and a DVD player (S-video connection) are connected

to the projector, pressing this button switches between the two. There is a three-second delay

before the alternate display source appears.

When you press the VCR/DVD Player button, you switch to the input source that was last active.

For example, if you view a DVD and then switch the display source to the internal computer,

pressing the VCR/DVD Player button will switch the display source to the DVD player.

IMPORTANT

The 4000i is optimized for use with a high-resolution computer data signal.

To switch to a connected VCR or DVD player

VCR/DVD Player

Internal Computer

Guest Laptop

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

No comments

Smart-technologies 4000i User Manual Page 30